Huston we may have a problem.

[Coloradobluesguy]

Maybe it’s part of the puzzle but I fell into what I assume is a trap now the maze is reset and the inner shaft won’t make a full rotation did something break or is it another lever trick to figure out?

[mereacregrigore18]

It should make a full rotation.

[mattangel]

Try with a BiT more force

[jimbo]

Mine also started doing this too. Like already said a little extra force moves it past that jam point. I hope to open it and remove the debris if that’s what it is.

[doc81]

I never had this issue but I know some have reported this in the forum on Bronze. It sounds like a bit more force fixes the issue.

[bob2187]

This just happens to me. I really feel like I’m going to break it if I give it more force. Any ideas?

[ghxost]

If not sending into be fixed is the next step

But the reason behind saying try a little harder is sound logic. There is a good reason it could happen and that would be the only applicable fix I can think of if its fixable by you...

[Aldan]

This just happens to me. I really feel like I’m going to break it if I give it more force. Any ideas?

Hi,
another thing you can try is to rotate the core fast left and right so that it hits "the obstacle" with a greater speed. This did the trick for me when I got stuck. After that it didn't get stuck anymore.

[Brassassin]

Hi,
another thing you can try is to rotate the core fast left and right so that it hits "the obstacle" with a greater speed. This did the trick for me when I got stuck. After that it didn't get stuck anymore.

Same for me. I was quite excited when I this obstacle. I read some things about it in the progress thread that made me worry not so much about it.