Mapping Challenge

[ghxost]

Ok, who wants to go half on a printer, haha!

Edit: page 15 link is r1 right? I may have a friend at work, I'll see if I can get two printed. And no not for now haha

[ReallyBigTeeth]

I'm not sure what an "r1" is, but the link at the top of page 15 is for the metal Revomazes with a septagonal/heptagonal core. I made two designs for the same Revomazes. The latest (and recommended) one is here: https://www.thingiverse.com/thing:2831530

If "r1" refers to the Obsession Revomazes, there is a .zip file attached near the bottom of page 16 that should work. I don't have an Obsession and didn't get any feedback on that design, so I didn't published it on Thingiverse.

[ghxost]

I meant v1...

[doc81]

ghxost...you can use third party 3d printing services on thingiverse and pay them to print you the object. There is a button on the right called "order this printed" to do this. I have used this to print ReallyBigTeeth's gripper which works perfectly to get a better grip on the puzzles and avoid sore fingers. It also makes it easier to map rotation for me as the core is what I move to solve the puzzles (my friend moves the sleeve).

That being said...I believe that the mapper works exactly as intended and quite well...making the mazes alot easier than if you were not to use it. Ultimately it's everyone's decision on how to solve the puzzles...whether to map or not...how you map...etc...I personally decided that I won't use the mapper because these puzzles are not cheap and I do want some challenge out of them.

[Crypton]

I'm not sure what an "r1" is, but the link at the top of page 15 is for the metal Revomazes with a septagonal/heptagonal core. I made two designs for the same Revomazes. The latest (and recommended) one is here: https://www.thingiverse.com/thing:2831530

If "r1" refers to the Obsession Revomazes, there is a .zip file attached near the bottom of page 16 that should work. I don't have an Obsession and didn't get any feedback on that design, so I didn't published it on Thingiverse.

I'm currently printing the Obsession mapper ('ve been frustated by the black Obsession)...
Will tell you how its fits over the weekend.

[ReallyBigTeeth]

Anyone looking to print my mapper design for an Obsession maze may want to hold off for a day or two. Crypton's feedback has got me thinking that there may be Obsessions with different diameters for the ends (handles/grips). His measurement is 20.55 mm, and cmh714's measurement was 23.86 mm. Can anyone confirm?

The files on Thingiverse for the metal Revomazes are fine. It's just the design file for Obsession mazes near the bottom of page 16 of this thread that may not work properly.

I'll upload new design files to fit both diameters this weekend.

[Crypton]

As I mentioned in my pm, I have Obsession V2, where the shaft/core can be extracted.
I don't own V1 Obsessions, where the shaft/core cannot be removed.

[ReallyBigTeeth]

I wonder if it's safe to assume that all V1 Obsessions have the larger diameter core ends, and the V2 Obsessions all have the smaller ends. I've labelled the files that way and included them in this post and in the post on page 16.

V2 & Obsession.jpg (254.5 KiB) Viewed 11956 times

[Chyron]

Going to print them all tonight and try them out tomorrow, thanks RBT

[ghxost]

I got grips and stands printing. Thanks for the stuffs.