REVOMAZE User Group

Just something I cooked up.........I wish I had the Mazes to go on it.

Nice, very nice!
May I challenge you to design such a 'stand' that can hang on a wall?

Should design something that is modular. Clips together like a puzzle, expands for each new maze.

Would like one that had body and core separate

AFKAN wrote:Would like one that had body and core separate

Perhaps a vertical case where the core and sleeve are grasped by two separate grips such that the press of a button slides the two apart? Then again, that would only be intended for puzzles without pins Can you imagine a case that tears apart your mazes and leave behind a mangled mess of their former selves

I like the modular idea. I was thinking of that idea while making this. I'm going to try and made something that is (as suggested above) wall hangable if desired, plus modular.

Keep the ideas coming.

take a look at tales's. I really like what he did

http://www.revomaze.co.uk/phpBB3/viewto ... 9&start=20

That's a good idea! I want to make something that doesn't have as much real estate.

So I thought of an idea that would be modular in design but am having trouble with making it work.

The idea is to have the base of the stand much like a puzzle piece connect to one that is left or right of it. But, I want the connecting pieces to be made up of the word REVOMAZE which is etched into the base and is cut out on one side and protruding on the other.

The problem is I'm not a designer and can't think of a way to design the word in that way.

Anyone got any Ideas on how this can be done?

Also, so people can design modular stands as they like, a similar cutout would be on the top edge and lower edge of the stand.

To make it hangable on a wall, the arms of the stand would be shaped with a semi circular cutout on the top AND the back edge. This would allow people to use it on table-top and on the wall.

I really like the idea of incorporating the certificate into the stand. (Kudos to tales's homemade design.) I'm still trying to think of ways to do that.

Let me know what you think....

Ok here it is, The ULTIMATE stand. It is modular, can be put on a wall OR a table/shelf and holds the certificate, and can hold the shaft seperately. Any other ideas? I'll pretty it up if we can't think of anything else.