REVOMAZE User Group

Hi,

Where can I find the precise instructions for reassembly of the copper revo?
How to put the pins, to which hole and so on

thanks for your help

I haven’t opened copper yet, but for all other Revos there is a special ‘Open’ section for the specific puzzles.
You can get acces to that by asking Shane, Darctangent on this forum (via Private Messages). You can read more info on this here: viewtopic.php?f=3&t=821#p12648

revo wrote: ↑Mon Nov 30, 2020 6:33 pm Hi,

Where can I find the precise instructions for reassembly of the copper revo?
How to put the pins, to which hole and so on

thanks for your help

Even in the open forum for copper there are no specific assembly instructions for copper. I assume it's the same as the generic static mazes. I've solved it but my pin is stuck in the sleeve. What questions do you have about reassembling?

yes, this is a shame that there are no specific instructions for each revo. Especially for copper the maze pin is not the same as the previous revo

I managed to reassemble

my questions were:
- on the rod where that was the certificate, which hole for which pin and the orientation for each pin in their respective hole (round up or down?)

Draw hole is shallow and a little smaller.
Maze hole is larger and deeper, and it is at the end of the maze’s main ramp.

Draw hole pin goes in rounded side up.
Maze hole pin goes in bevelled, chamfer side up.