REVOMAZE User Group

Not sure if this is the right place, but, As I do not have access to a 3D printer, and these “mapping aids” seem to be the best way to go, would any of you that have created one be willing to sell me one? My mapping skills have epically failed in the past.

Will your method still work if I can’t get the maze back to the starting neutral position?

am going to attempt my first map on my first Revomaze, the GM. After some quick calculations and a few sheets of graph paper later, I have a grid space that is 80 high and 30 wide. (80 represents the length of the shaft as it moves through the cylinder. The 30 is the rotation) If I hold the maze upr...

I am going to attempt my first map on my first Revomaze, the GM. After some quick calculations and a few sheets of graph paper later, I have a grid space that is 80 high and 30 wide. (80 represents the length of the shaft as it moves through the cylinder. The 30 is the rotation) If I hold the maze u...

This was given to me as a gift with no knowledge of difficulty and that I should have started earlier. I “BRIEFLY” got it back to the start point where both “hex” were equal and swiveling 360•. I found a single point of resistance and assumed it to be the starting point. I pulled on the right hex an...

Absolutely love this puzzle! GM is my first. I have had it about 6 months and am still unable to get it back to the starting point. I know I am in a trap, but am unable to get out. I believe it is the first trap. I can almost get the bolt back to its original "even" position, but not quite...